MIL-DTL-82125B(MC)
woven of first quality, continuous filament, rayon yarn and the
finished tape shall conform to the following requirements:
Width (inches)
1/2 + 1/16
Weight per gross yd (ounces)
5.0 minimum
Thread count, total ends
66 minimum
Picks per inch
52 minimum
Weave
plain
3.3.9.1. Color and colorfastness. The tape shall be dyed a shade
approximately the color of the basic material and showing good
fastness to crocking and wet (dry) cleaning.
3.3.10 Fasteners, snap. The snap fasteners for the front edge of
cape shall be brass, black, japanned finish, round style, rolled
edge, size 15-line, sew-on type.
3.4. Design. The cape shall be the U.S. Marine Corps design
shown on the attached figures; fully-lined cape, arm slits, snap
fasteners on the fronts, one button, ornamentation piece at the
fronts; having a two piece back with a center pleat and roll
rounded collar.
3.5. Patterns. The standard patterns furnished by the Government
shall not be altered in any manner and shall be used only as a
guide for cutting working patterns. The standard patterns
provide 3/16 inch allowance for seams at the top and front edges
of cape and joining top collar to under collar, 1/4 inch
allowance for collar and collar stand, 3/4 inch allowance for
side seams, and 3/8 inch for all other seams. The patterns show
size, seam allowance, directional lines for cutting, and are
marked or notched for proper placement and assembly of component
parts.
3.5.1 List of pattern parts. Capes shall be cut from the
specified materials in accordance with the pattern parts
indicated:
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business