MIL-DTL-29396B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
55 Set collar.
Finished appearance. The collar
shall be carefully joined to the
jacket without distortion of the
collar.
a. Mark the neckline on the outside
3/8 to 1/2 inch from collar notch up
to the shoulder seam and gradually to
within 1 to 1-1/4 inches at the
center back for position of collar.
b. Position the collar with the
lower edge lapped on the outside top
edges of the jacket at the mark.
c. Stitch the collar from end to
301
LSa-1
10-14
A
A
end, to the jacket, as close as
(silk)
possible to, but not on top of, the
stitching for the piping at the lower
edge of the collar. The stitching
shall not be through the collar
lining.
56 Set sleeves.
Finished appearance. The armhole-
sleeve seam shall finish without
twists, gathers, puckers or pleats.
a. Position sleeves on outside of
jacket at the armholes, with the back
notch matching the side back seam,
and with notch in top sleeve and
front matching.
b. Join the sleeve to the jacket
301
SSa-1
10-14
A
A
with a 3/8 inch seam, distributing
the fullness in accordance with good
manufacturing practice.
c. Press the entire armhole smooth
and flat with a heated pressing iron
to remove fullness, exercising care
not to stretch the armhole.
57 Baste armhole.
a. Baste around the entire armhole
Hand
on the inside, holding the back
or
lining, shoulder pad and front lining
301
Hopper
in place and distributing fullness
evenly. Turn jacket on the outside.
35
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business