MIL-DTL-29396B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
44 Baste back lining to jacket.
Hand
a. Fold the back lining, forming
approximately a 1 inch wide pleat at
or
the center back. Baste the back
301
Hopper
lining to the jacket along the center
pleat from the top approximately 3
inches from the bottom finished edge
of jacket.
b. Baste back lining to jacket
Hand
starting at side seam and continuing
or
approximately 3 inches from the
301
Hopper
armhole and shoulder edges, allowing
room for shoulder pad.
c. Turn under the bottom edges of
Hand
front and back lining, and baste
or
along the bottom edge of jacket, with
301
Hopper
the folded edge of lining positioned
approximately 1/2 inch from the
bottom piped edge of jacket.
45 Fell lining to bottom piping.
a. Fell the turned under portion of
301
EFc-1
6-8
0
0
lining along the bottom piping of the
or
(b)
(silk)
jacket with blind stitching 1/4 to
Hand
C
3/8 inch from the bottom folded edge
(silk)
of lining. Only the under ply of the
folded edge of lining shall be caught
in the stitching.
46 Trim lining and interlining.
a. Trim the excess jacket front
interlining and front lining at the
armhole.
b. Trim the back lining even with
the neck.
46 Trim lining and interlining.
(cont'd)
c. Trim the shoulder edge of the
front and back lining to
approximately 3/4 inch from shoulder
at the armhole edge and taper the
trimming to 3/8 inch at the neck.
31
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business